Sunday, February 28, 2016

3-D Etched Lid for Wedding Card Box


 Our Family has a joyous event coming this next August.  Our only daughter is getting married.  It has fallen to me to do much of the DIY decorating, cards and favors for the wedding.  I am thrilled to do so and this 3-D card box will be a nice addition to our wedding decor!

I started by gathering the supplies I would need to make my box.  I have pictured some of them in the photograph below.

For this project you will need the following:  

Etchall (R) reusable etching creme
Etchall (R) etchmask and transfer sheets

Die cut machine and die with wedding sentiment
12" Cardstock: Black; Black and White chevron design
Wooden Box with hinged lid:  12" wide x 3-3/4" deep
Vintage white Wooden Frame:  5 x 7"
Paints:  Teal, Vintage White, Matte Sealer
Paintbrushes:  1" flat, #6 fan brush
Embellishments:  Faux clear rhinestone trim with adhesive back; Pearl and Rhinestone adhesion's from a package.
Scissors
Paper Trimmer
Glue

Instructions:

Disassemble the frame. Discard the cardboard back and paper mat. Carefully remove, then wash and dry the glass.

Measure the space under the frame to decide how big to make your paper cut for the sentiment. Cut the sentiment from Black cardstock to get the right size for the space.

Using the same die and size; apply the transfer paper to the etchmask and cut out.  The etchmask image should be the same size as the black cardstock die cut.       

Remove the release paper from the yellow etchmask and adhere to the center of the frame glass. Follow the manufacturer's instruction and add the Etchall etching creme to the glass. When the time is up; scrape the etchall creme back into the bottle for another use. Then; thoroughly wash the glass in warm water before removing the Etchmask. Finish by removing the etchmask, rinse; then dry with a lint free towel.
Paint: Center the frame on the top of the lid and trace around the inside with a pencil.  Leave this portion of the lid white.  Paint the entire box vintage white.  Paint the top of the lid (Except for the middle portion) and sides of the lid teal.  Allow to dry.  Use the fan brush (dry) to apply vintage white to the frame and box lid to give it a distressed look.  Replace the glass in the frame and use the metal brackets to hold it firmly in place.  
The next step is the trickiest part.  Adhere the black cardstock sentiment directly under the etched portion of the glass.  This is what will give it the 3-D effect.  Center and glue the frame to the box lid. Double check to keep everything straight.

Cut the chevron cardstock as follows:  two 1-1/2" x 12" pieces for front and back; two 1-1/2" x 8-     3/4" for the sides. Cut 1/2" strips and glue around the sides of the frame. Make sure the seam is in the back.

 Finish: Complete by embellishing the box with the faux rhinestone trim and the adhesions.

Now it is ready for the wedding cards!  

This design can be adapted for any theme, party or color.  Enjoy!


Make sure to enjoy the small blessings along the way and,

Live Life with a Flourish!

Marilyn








No comments:

Post a Comment